Essentials BLISS CURVED TOP CRIB 2712 - Step-by-Step Crib Assembly

1. Tighten the bracket (M) onto mattress base (E) using 8
pcs Lock washer (K) and 8 pcs Bolt 3/4" ( 20 mm) (G)
(Fig. 1). Carefully place mattress base into the crib taking
care not to scratch the
fi n i s h*.
*N o t e
: The mattress base may be at the highest level when
the child is born. It must be at the lowest level before the
child can stand up.
-
9
(D 
7 -
INSIDE / INTRIEUR
-.-  — s
(
FACE/AVANT
(Fig.2)
2.
Insert 4 pcs Lock Washer
(K)
and 4 pcs Bolt I
3/4"( 45 mm. ) (F) through the
holes in the
sideboard and connect sideboards (C) to headboard (A)
by using
4
pcs Jcn Nut
(I). Screw in 2
pcs Lock washer
(K), 2
pcs Bolt 2
3/16"
( 55 mm.) (H) and 2 pcs Barrel nut (J) to both ends of
/
/
I
1
\
Q
/ /
RIGHT
/
DR011
INSIDE
I
INTRIEUR