Essentials Pro 2 - 7
1. Remove bur.
2. Place chuck opening against tapered end of chuck cleaning nozzle.
3. Press start. See Maxima XTEND instructions for additional information.
Manual Cleaning and Lubrication with Henry Schein® Spray & Clean (102-8721)
Handpiece Maintenance (Fig. 6)
Fig. 6
1. Disconnect handpiece from air supply.
2. Insert nozzle into handpiece drive air tube and spray for approximately 3 seconds.
3. Attach the handpiece to an air supply or purge station and run for approximately 20 seconds to remove debris and excess lubri-
cant. A spray cover or paper towel should be used to contain expelled lubrication.
To Next Page
Loading...