eta Fenite - Using the Device; Skin Care After Use

After switching on the device, the automatic mode is activated by pressing and holding the
A2 button for 2 seconds. The switch-over is signalled by an acoustic signal. Use the same
procedure for switching the device back to the manual mode.
WARNING
– At lower levels of setting, the intervals between the flashes (or heating the lamp) are very
short. If you operate in the automatic mode, you must continuously slide the light exit
window, to prevent multiple flashes on the same area.
– When the device is switched off and then switched on again, i tis activated in the mode in
which it was switched off. However, if the device has been unplugged, when switched on
again, it is activated in the default manual mode.
– For safety reasons, if the application window does not move, if in manual mode, the
release of flashes will be automatically interrupted after 8 seconds.
Usingthedevice
1) Select and by simple snapping place the selected attachment. If the device is switched
on without an attachment placed on it, the HR and SR will flash on the display B
signalling the missing attachment. To remove the attachment, use the same procedure
(see the detail on the picture 1).
2) Put the connector of the adapter to the device socket A5. Then put the adapter in the
wall socket. The sign "OFF" will be lit on the display and an audible signal will sound.
Now the device is in a standby mode.
3) To switch on the device, press and long hold the button A1. An audible signal will sound,
the integrated vent will be activated, and the display will be lit, indicating the marking of
the attachment placed (HR or SR), the flash intensity set and numeric indication of the
amount of remaining flashes for given attachment
4) If needed, change the flash intensity setting and the mode of use.
5) Put on the safety eyewear D.
6) Press the device onto the skin area to be treated. In automatic mode, the flashes will be
released immediately. Thus, it is necessary to continuously slide the application window
to the next area, so there is only a partial overlap and always move to the new area of
the skin. In manual mode, press and release the application button A2 to release
a flash.
7) When you have finished the treatment, press and long hold the button A1 to switch
off the device and unplug the adapter from the wall socket. In case of inactivity lasting
for more than 5 minutes, the device will be switched off automatically. Then let the
device and the attachment cool down. Then perform routine maintenance and store the
device in well-ventilated place out of reach of children and persons with reduced mental
capabilities.
Skincareafteruse
Approximately 20 minutes after the treatment, you can apply moisturizers or regenerative
lotions to the treated area. If you experience discomfort or skin irritation, you can calm
the area by applying a cooling cloth (for 30-60 minutes). Do not use irritating cosmetic
products! Do not moist the treated area with water for approximately 2 hours after the
treatment.
40
GB
/ 71