NOTE
Light impulse may cause a sensation of warmth or heat. In some cases, your skin may also
slightly tingle. However, it should never be painful.
C)Setting
Based on the warnings in these instructions, evaluate, if your current health and skin
condition allow the use of this device.
HOWTOUSE
Skintolerancetest
Before using the device for the first time (regardless the intensity degree) it is necessary
to perform the tolerance test on a small skin area. It will help you to verify, if this type of
technology is well tolerated by you and to discover any possible unwanted reaction of your
skin. The test should be performed at least 24 before a complete treatment.
The tested area should be hair-free, clean and free from any cosmetic products.
Then release 2-3 flashes close to each other at a low intensity of 1-2. Wait 24 hours and
check your skin for any unwanted reactions (erythema, the skin must not be sensitive or
swollen, nor you should experience any discomfort). If any complications occur, do not use
the device and for further actions consult your physician/dermatologist.
After having performed the skin test, do not perform any treatment on the tested area
for at least one week (by any of the attachments).
Modesofuse
2 basic modes of the use of the device are available.
a) manual - it is a default mode, which can be simply described as a mode when each
flash of light must be induced by pressing activaton button A2. Use for more
precise treatment of your face or other, rather small, parts of your body.
Proper contact with your skin and the possibility to release a flash is signalled
by flashing A6 signal lamp and C4 sensor. If the application window is not in
proper contact with your skin, the A6 signal lamp and C4 sensor are lit.
b) automatic - in this mode you can just press the application window C3 onto your skin
with no need to press the activation A2 button. Then the flash releases in
certain intervals will be activated automatically. It is suitable for treatment of
larger areas.
Active mode is signalled by continuous flashing of A6 signal lamp and C4
sensor. Once the application window gets close to the skin, the flashes start
to be released automatically.
GB
39/ 71
To Next Page
Loading...
