ETAS ES583.1 - Software

ES583.1 - User's Guide28
Technical Data ETAS
5.2.2 Software
Supported applications and software prerequisites
For the configuration of the ES583.1 as well as the control and data acquisition,
you need software in the following versions (or higher):
General
• HSP V10.4.1
• ES583.1 USB driver
Supported software interfaces
ETAS provides the Software Development Kit "ECU Bus Interfaces and Integra-
tion - Package" (EBI-IP). Using this SDK, customers can develop drivers for the
hardware access to integrate the ES583.1 module in their own application soft
-
ware.
Inter-
face
Application /
Protocol
Classifi-
cation
1)
Support in the
application software
FlexRay XCP on FlexRay MC
1)
INCA V7.1.4 SP4
3), 4)
FlexRay Monitoring MC
1)
INCA V7.1.4 SP4
3), 4)
UDS on FlexRay D
2)
INCA V7.1.4 SP4
3), 4)
1)
: MC: Measurement and Calibration
2)
: Diagnostic
3)
: additionally INCA-ES5xx Add-On V7.1.4 and higher
4)
: additionally INCA-FlexRay Add-On V7.1.4 and higher
Note
Operating the ES583.1 with older software versions is not possible.