Need help?Do you have a question about the ETATRON D.S. MP Series and is the answer not in the manual?
Dosing pumps are used to adjust pump capacity for various applications.
Highlights potential hazards such as leakage from worn gaskets and component degradation.
Procedures for inspecting the pump for shipping damage upon arrival.
Recommendations for short, properly routed suction pipes with appropriate bends and diameter.
Shows a recommended setup for installing a pulsation damper for better performance.
Covers pre-start checks, oil level, motor rotation, and initial startup for air bleeding.
Explains how to adjust pump capacity using the manual stroke adjustment knob and nonius.
Notes that manual adjustment procedures do not apply when using a servo control.
Provides a scheme and steps for correct installation and adjustment of overflow/overpressure valves.
Details visual checks and tasks for ensuring pump security and high performance over time.
Addresses issues such as liquid leakage, reduced capacity, and air in the delivery pipe with corrective actions.
Instructions for disconnecting, cleaning, and replacing gasket packs in the pumping head.
Procedure to ensure water-tightness by adjusting and compressing PTFE gasket packs.
Method for continuously washing gaskets to remove deposits and prevent hardening.
General| Frequency | 50/60 Hz |
|---|---|
| Voltage | 230V AC or 110V AC (depending on model) |
| Control | Manual |
| Material (Pump Head) | PVDF, PP |
| Material (Seals) | EPDM |
To Next Page
