What to do if ETATRON D.S. eOne MA Water Pump is not metering?
If the ETATRON D.S. Water Pump isn't metering, ensure the check valve is correctly mounted and not deteriorated; if it is, mount it properly or replace it. Also, check the membrane and replace it if deteriorated. Examine the magnet fuse and electromagnet, replacing them if blown. Check the magnet resistance too.
Why no LEDs switched on ETATRON D.S. eOne MA?
If no LEDs are switched on your ETATRON D.S. Water Pump, verify that the pump is correctly powered by checking the socket and plug.
How to fix electronic part that does not transmit pulses to the magnet in ETATRON D.S. eOne MA?
If the electronic part of your ETATRON D.S. Water Pump isn't transmitting pulses to the magnet, it might be due to a blown electronic board caused by overvoltage or lack of earthing. Replace the board to resolve this issue.
Explains symbols for safety, prohibition, warnings, and information.
Provides crucial safety information for installation, use, and maintenance of the pump.
Guidelines for handling hazardous liquids and toxic fumes during operation.
Specifies the pump's design purpose and prohibits other uses.
Procedures for safely packing and returning equipment for service.
Information on pump assembly, referring to appendix for clarification.
Step-by-step instructions for safely dismantling the pump.
Details warranty period, exclusions, and conditions for validity.
Explains the electro-magnetic PTFE membrane mechanism of the dosing pump.
Lists key technical specifications like casing, power supply, and environmental limits.
Lists directives the dosing pump complies with.
Provides dimensional drawings and measurements for wall mounting.
Details materials used for pump parts in contact with chemicals.
Introduces the section on installing the pump, hoses, and wiring.
Guidelines for optimal pump placement regarding temperature and liquid level.
Wiring diagram and electrical connection safety requirements.
Step-by-step guide for connecting suction and discharge tubes to the pump.
Illustrates a standard system setup with labeled components.
Lists standard accessories included with the pump.
Explains manual flow rate adjustment using controls.
Details the function of each button and LED on the control panel.
Provides a detailed explanation of each command and indicator light.
Describes pump behavior and alerts for pressure or fluid issues.
Explains the level alarm and external signal input functionality.
Shows terminal board layout and connections for meter and level probes.
Details standard configurations for injection valves.
Options for injector length and counterpressure levels.
General| Protection | IP65 |
|---|---|
| Type | Dosing Pump |
| Pressure | up to 20 bar |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Operating Mode | Automatic |
| Material | PVDF |
To Next Page
