The values listed above are intended to be within a tolerance of +/- 5%. They were obtained by a series of test
performed on similar equipments with water at temperature of 20°C.
Overall dimensions
Fig. 1 - Dimensions in mm. Plate for wall mounting.
Material in contact with the additive
In the standard configuration the pumps of the "eOne" series are supplied with the following materials:
Membrane Seals Valves Connections Pipes
PVDF PTFE TFE/P
CERAMIC
TFE/P
PVDF PE / PVC PP
INSTALLATION
Introduction
This section describes steps for installing the pump, hoses and wiring. Please read this instruction before starting any
activity.
Follow these guidelines when installing the pump:
• Make sure the pump is powered off and any other related equipment before starting any activity.
• In case of any unusual events or warning signs, stop immediately. Start again only when you are absolutely
sure that any possible problem has been solved.
• Do not install the pump in hazardous environments such as at risk of fire or explosion.
• Avoid risk of electrical type and or fluid leakage. Never use a damaged or defective pump.
To Next Page
