Etec EKEPC3 - EKEPC3 Controller Guidance; Boot Distribution Network Setup

9
TheinstructionmanualforOCPP-1.6Jprotocol
controllerofelectricvehiclechargingpile
GuidenceofEKEPC3(OCCP1.6J)controller
1.Bootdistributionnetwork
1.1.1Connecttothepowersupplyandstartup,thenswipethe
dediciatedcardfornetworkconfigurationtohelptheWIFIsignaltobe
avaliabletolinkbydevice.Ifthecardislost,pleasecontacttothe
manufacturetoreplacethecard.
1.1.2ICcardsupportedbythiscontroller:contactlessICcard,13.56MHz,
M1withprotocolISO14443A
standard,IC-UID、IC-CUID、IC-FUID、IC-UFUID,etc.
1.1.3Forcardwhichisreleasedbyourcompany,TheTagIDisalready
writtenwhenitwasproduced.ThenumberofTagIDwillbemarkedon
thecard(with9-digitdecimal).
1.1.4Forcardwhichissetbyyourself,theRFIDmodulewillreadthe
serialnumberwhichissolidifiedincardastheTagIDnumber(with
8-digithexadecimal).
1.1.5IfyouusedtheRFIDfunctiononyourcontroller,thenyouneedto
addtheTagIDatlocaldeviceorthebackgroundplatformofOCCP
operationaccordingtotherequire,tohelpyouaddTagIDintoyourlist.