EasyManua.ls Logo

Etec ML108 - Intended Use

Etec ML108
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page | 4
Disconnect the appliance immediately from the power supply if it falls or becomes severely
damaged.
• Have the unit checked for safety by a qualified technician before using it again.
Do not turn off the unit immediately after exposure to strong temperature fluctuations (eg
during transport). The resulting condensation could damage the unit. Do not turn the unit on
until room temperature is reached.
Turn the power off immediately if it is not working properly. Pack the device carefully
(preferably in the original package) and send it to your dealer.
Suitable for adult use only. The appliance must be placed out of the reach of children.
Never leave the connected device unattended.
Only use replacement fuses of the same type and performance as the fuses already
contained.
The user is responsible for the correct positioning and correct operation of the device. The
manufacturer is not liable for damages caused by incorrect use or incorrect installation.
The unit falls under protection class I. Therefore it must be earthed with the yellow-green
cable.
There may be too little smoke or odor during initial start-up. This is not unusual and does
not necessarily mean that the device is not working properly.
Repairs, maintenance and electrical connections may only be carried out or handled by
qualified technicians.
ATTENTION! EYE DAMAGE!
Never look directly into the light source.
(Especially epileptics)!
Intended Use
This unit is not suitable for continuous operation. Maintaining regular operating breaks
increases the life of the unit.
• The minimum distance between the light source and the illuminated area is 0.5 meters
The maximum ambient temperature for operation is ta = 45 ° C and must never be
exceeded.