Page | 7
4. Power cables must be undamaged and must not show any signs of material fatigue.
Replace fuse
Overvoltages, short circuits or unsuitable mains connections can cause a fuse to burn through. The
device does not work when the fuse is blown. If your device burns a backup, perform the following
steps.
1. Disconnect the mains plug.
2. Insert a flat screwdriver into the slot of the fuse cover. Lever the cover gently. The fuse now
comes to light.
3. Remove the old backup. If you look brown or milky, it is burned.
4. Insert the new fuse into the holder. Close the cover. Use only a fuse of the same type and the
same specifications. Observe the label with the technical data.
Product description:
The ETEC ML108 is a giant WashlightMoving Head with a stunning 108 x 3 Watt LED RGBW Power! It
has been developed for large stages and events, which require a very strong light output. The 3 Watt
LED's, which are divided in the colors red, green, blue and white, offer a very nice color mixing and
extremely bright projections. Fast, smooth movements with 16-bit resolution, a graphical LCD display
for setting up all functions as well as for digital DMX addressing and a multitude of operating modes
make this clear: This moving head is a real full-featured! Both stand-alone modes with auto
programs, music control via built-in microphone, as well as an ingenious DMX control with 14
channels allow a wide range of applications and programming.
Technical specifications:
Voltage frequency: 50 / 60Hz
Operating modes: DMX512, automatic, master /
slave, music-controlled
Diodes Type: Single LEDs (R24, G28, B28, W28)
Number of diodes: 108
Diode Power: 3W
Color: RGBW
Beam angle: 15 °
Number of DMX channels: 9/14
DMX standard: DMX 512
AC IN: powerCON
AC OUT: powerCON
DMX IN: XLR - 3-pin
DMX OUT: XLR - 3-pin
Protection class: IP20
Housing: ABS
Fan cooled
To Next Page
Loading...