ETEK Optima - Technical Characteristics

____€
7. TECHNICAL CHARACTERISTICS
ANALOG INPUTS
Connectors: KLR and 11'4" jack
Type: RF Filter, balanced Input
Impedance: 40 IiOhm balanced, 20 kOhm unbalanced
Nominal Operating Level: ~1DdBV to +4dBu
Maximum Input Level: +14 dE-lu
ANALOG OUTPUTS
Connectors: XLR and 11'4" iack
Type: RF Filter, balanced Output
Impedance: ED Ohm balanced. 40 Ohm unbalanced
Maximum Output Level: +14 dBu
SYSTEM SPECIFICATIONS
Bandpass: ED Hz - so kHz, +i'- 0.5 dB
Noise: :=- - SD dB
THD + Noise: D.D4'=lti O D dB, 1 kHz
Crosstalk: -i: - BD dB
INTERFACES
MIDI: 5 pin DIN Connectors, IN i’ OUT if THRU
Serial. RS232, 9-pole male connector
Expansion: 26-pole Female Connector
DIGITAL ELABOFIATION _ _ _ _ _ .
LISP Prijigeeeigir: AIJIIIIOI 24 hit, CDBIIIOIBFIIS. SEDDII
~ I AG‘-OP A tomatic Gain Contr ) _
§§L'i.§§§.l-',?" so bit 5[Igl'TIEi-EIBIIEI, oversampling 64.1128 times
Sampling Frequency: 43 KHZ
DISPI-RY .
Type; 3 CI'IEII'EtCI.EI' LED DISDIHY
v REOUIREMENTS
53:9? SUPPL ioo-12o v ec. 2oo-24o v ec. so-so Hz
Power Consumption: 1'3 Walls
Power Connector: Standard IEC connector
PHYSICAL SPECIFICATIONS
Size (H x L x D): 44 x 483x EDD mm.
Weight: 1-5 kg
ETEK ie eiweye eirivirig to improve the quality of its products. Consequently. it resenres the right to
modify the specifications of any products in the line that have already been released onto the market,
wiihciii previous notice. Specifications and external appearance can therefore differ from the those
iflustrated in the present documents-
(c) 2000 ETEK. Printed in China
16
-I
I
.+-E.-*1‘-Pt
-‘I-T‘ i-"=s-Si-iii‘-iii »:£‘L'§3lE-~'1fl-
.-I-. _.iI|__i-.iI _l.n.
I
‘I
-1