How to fix unreadable status on ETEKCITY JPD-FR100+?
Ensure the forehead is clean, dry, and free from perspiration before taking a measurement with your ETEKCITY Thermometer. Also, avoid direct sunlight during the measurement process.
How to ensure correct sensor placement for ETEKCITY JPD-FR100+ Thermometer?
To ensure accurate readings with your ETEKCITY Thermometer, make sure the sensor is fully inserted into the ear canal without causing harm.
What to do if ETEKCITY JPD-FR100+ Thermometer shows measurement operation error?
Make sure to slowly scan across the forehead while keeping in contact when measuring forehead temperature with your ETEKCITY Thermometer. Do not keep the sensor in place during measurement.
Why ETEKCITY JPD-FR100+ Thermometer shows unreadable status in ear?
Before using the ETEKCITY Thermometer to measure ear temperature, ensure that the ear canal and eardrum are completely clean and dry.
What to do if physical condition is unstable when using ETEKCITY JPD-FR100+?
If the physical condition of the subject is unstable, allow them to rest for about 30 minutes before attempting to take a temperature reading with the ETEKCITY Thermometer again.
General| Type | Infrared Thermometer |
|---|---|
| Response Time | < 500ms |
| Distance to Spot Ratio | 12:1 |
| Display | LCD |
| Power Supply | 9V Battery |
| Display Resolution | 0.1°C/°F |
| Battery Type | 9V |
| Auto Shut-off | Yes |
| Backlit Display | Yes |
| Laser Pointer | Yes |
| Temperature Range | -58°F to 1022°F (-50°C to 550°C) |
| Measurement Range | -58°F to 1022°F (-50°C to 550°C) |
| Measurement Distance | Up to 12 inches |
| Power Source | Battery |
| Emissivity | Adjustable from 0.1 to 1.0 |
To Next Page
