How to transport Etesia Lawn Mower?
To transport your Etesia Lawn Mower: * It is better to use a loading ramp to load or unload the mower on a trailer or a utility vehicle. * Apply the parking brake and place chocks under the wheels. * Close the petrol tap. * Tie down your mower with straps run through the tow hook and the slot of the tow hook.
How to tow Etesia SKM Lawn Mower?
To tow the Etesia Lawn Mower, remember the following: * Set the hydrostatic axle bypass to the position [ O ]. * Use only a tow bar for an attachment to the telework at the front of the mower. * After movement, remember to put the hydrostatic axle bypass back in the operating position [ I ]. * Towing must only be carried out over short distances and at low speed (less than 5 km/h). * For towing over longer distances, use a suitable means of transport (trader or utility vehicle).
How to move Etesia SKM Lawn Mower with engine off?
To move the Etesia Lawn Mower with the engine off, set the hydrostatic axle bypass control to [ O ].
How to change wheels on Etesia SKM?
To safely change the wheels on your Etesia Lawn Mower: * Stop the engine and remove the ignition key. * Apply the parking brake and immobilize the machine using chocks under the rear wheels. * Place a jack at the front, beneath the chassis, and lift the mower. * Secure the machine by standing it on stable screw jacks. * Remove the protection covers then pull out the locking clips. * Operate in the opposite order for assembly, making sure that you clean and grease the wheel shafts. * Check the tire pressures: 1.2 kg/cm2. For the other wheel: * Stop the engine and remove the ignition key. * Apply the parking brake and immobilize the machine using chocks under the front wheel and the other rear wheel. * Loosen the 4 attaching studs of the wheel to be removed. * Place ...
General| Brand | Etesia |
|---|---|
| Model | SKM |
| Category | Lawn Mower |
| Language | English |
To Next Page
