9
EN
Installation
1. Unscrew the case and open it.
2. Screw the rear cover to a door frame or to a wall.
3. Fasten the front cover of the keypad to the rear cover and screw them together.
Remark
Because of the tamper switch, opening the rear cover of the keypad when the latter
is on triggers the alarm. In such case, stop the alarm by disarming the system, as
explained in page 12 of this manual.
Setup
The ES-K1A operates under 4 modes.
Normal mode
The LED indicator blinks once every 5 seconds.
Sleep mode
Under Normal mode, the keypad switches to Sleep mode if no operation is made for
35 seconds. Press the Arm [ ] or Home Mode [ ] keys to exit Sleep mode. When the
keypad is in Sleep mode, the LED indicator is o.
RFID Reader mode
Under Normal mode, press [*] on the keypad to activate the RFID reader for 10
seconds: the LED indicator turns on. After 10 seconds, the LED light turns o as the
RFID reader turns o automatically.
Setup mode
To enter Setup mode, switch to Normal mode and then enter [your admin code + #]
on the keypad. The LED indicator blinks once every second. Press [*] to exit the Setup
mode and switch to the Normal mode.
After 30 seconds without operation, the keypad goes back to the Normal mode.
Default admin code : 123456
Remark
Correct operation: 1 beep and the LED light blinks once.
Wrong operation: 2 beeps and LED light blinks twice.
To Next Page
Loading...