EN 7
OPERATION
Switching on
1. Open the door to the dishwasher.
2. Press the ‘on-off’ button to switch on the device.
The check light End Program is on.
3. Select the desired program (see ‘program selection table’).
Select a cycle using the programming button.
The check light that is part of the selected program is on.
4. Close the door to the dishwasher.
The dishwasher will automatically start running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the ‘delayed start’ button. You can choose between a delay time of 3, 6
or 9 hours. Each press of the button changes the delay time.
The indicator of the selected delay time is on.
Then select the desired program and close the door of the dishwasher.
Indicators
• Water softener.
The indicator shows that you have to fill the salt container with
regeneration salt.
• Detergent.
The indicator shows that you have to fill the detergent reservoir.
• End program.
The indicator shows that the washing program has finished.
In addition, you will hear a sound signal five times.
Stopping or changing a wash cycle
1. Open the door.
2. Press and hold the programming button for more than 3 seconds.
The ‘End Program’ indicator is flashing.
3. Close the door of the dishwasher.
The machine pumps out for about 30 seconds Following the end of
this, a sound signal will click 5 times and the indicator shows that
the program has finished.
4. You can now select the desired program again (see ‘program
selection table’).
5. Now close the door.
To Next Page
Loading...
