ETNA VW149WIT - Error Codes

EN 22
ERRORS
Error codes
P1 P2 P3 P4 P5
interference type solution
* * *
Insufficient water supply • Make sure that the water
faucet is completely open
and that there is no crack
in the supply hose
• Check if the supply hose
is clogged
• Restart the dishwasher
Please contact the service
department if the problem
persists
* * *
Flooding safety enabled • Close the water faucet
and contact the service
department
* * *
The dishwasher is not
pumping out
• Check if the drainage hose
is connected
• Check the bottom sieve
and filter group
• Restart the dishwasher
and terminate the last
selected program
* * * *
Heating error • Please contact the service
department
* * * *
Flooding sound signal
activated
• Turn off the dishwasher
and close the water faucet
Please contact the service
department
* * * * *
Interference in the
electronics
• Please contact the service
department
* * *
Temperature in the
machine is too high
• Please contact the service
department
* * *
Interference of heating
sensor
• Please contact the service
department
Should the appliance become overfilled or exhibit excessive
leaking, shut off the inlet tap and alert the service department.