Etnyre Black-Topper User Manual (English)

Other manuals for Etnyre Black-Topper

Operation Maintenance Safety99 pages

Operation, Maintenance And Safety Manual71 pages

Manual20 pages

Operation4 pages

Questions and Answers:

B
Brenda LambertAug 12, 2025
What to do if my Etnyre Black-Topper Construction Equipment pump will not turn or turns slowly?
- V
  vgarciaAug 12, 2025
  If your Etnyre Construction Equipment pump doesn't turn or turns slowly, there are several possible causes: * The material in the tank or pump might be below the necessary pumping temperature. In this case, heat the material to the proper pump temperature. * There could be an air leak in the suction line. Locate and repair the leak. * The hydraulic system pressure might be low. Increase the pressure. * The hydraulic reservoir might have low oil. Add hydraulic oil to the correct level. * The spray bar valves might be set improperly. Correct the spray bar valve settings. * The hydraulic motor may be defective. Check for excessive case drain in the motor.
J
Jeremy KaneAug 15, 2025
Why is the hydraulic oil overheating in my Etnyre Construction Equipment?
- D
  Danielle HarmonAug 16, 2025
  If the hydraulic oil in your Etnyre Construction Equipment is overheating, consider the following possible causes and solutions: * The material in the tank or pump might be below the correct pumping temperature. Heat the material to the proper pump temperature. * There might be an air leak in the suction line from the reservoir to the filter and the inlet of the charge pump. Find and fix the leak. * The oil level in the hydraulic reservoir could be low. Add hydraulic oil to the correct level. * The spray bar valves may be set incorrectly. Make sure the spray bar valve settings are correct.
C
Charles VasquezAug 19, 2025
How to fix spray streaks from my Etnyre Construction Equipment?
- J
  Jonathan LozanoAug 20, 2025
  If you notice spray streaks when using your Etnyre Construction Equipment, it could be due to several reasons: * The pump speed might be too slow. Increase the pump speed. * The nozzles might not be at the correct angle. Adjust the angle of the nozzles. * The spray bar might be at an improper height above the ground. Adjust the spray bar height. * The material temperature might be too low. Heat the material to the correct temperature.