2
Installation - Pre-Installation Planning
26487-02A
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following pre-
installation considerations.
• Your sunbed operates from a 120V
AC source. You should have a NEMA
5-20R electrical outlet (like the one
shown below) installed in the room
in which you will use the unit. The
outlet should be on a dedicated cir-
cuit capable of providing 20 Amp
service. We recommend installation
by a professional electrician. The
outlet must be earth grounded.
20 AMP NEMA #5-20R RECEPTACLE
WARNING
Shock hazard.
Disconnect power before
servicing.
Air from the room is used to cool
the sunbed. Maximum ambient
room temperature should be 80°F.
Place your sunbed no closer than
6” from any wall. Make sure nothing
obstructs the airflow into the
sunbed’s endcaps or out of the fan
openings. A poorly ventilated room
may cause the unit to become hot
and cause discomfort to the user.
CAUTION
Proper assembly of your sunbed
requires three people. Plan to have
a couple of helpers assist you.
CAUTION
To Next Page
Loading...