0706
PREPARING FOR
INSTALLATION (IMPORTANT)
Check local laws for installation
If you are outside of North America, installation and wiring must be
performed by a licensed electrician. Always follow code standards when
installing wired connections.
Shut Power Off at the Breaker
OFF
WARNING:
electrical shock
•
•
• Properly ground fixture.
• Always follow code standards when installing wired
connections.
• If you are outside of North America, installation and
wiring must be performed by a licensed electrician.
Shut power off at the
If you don’t know where your
breaker is or how to turn off
power to your floodlight circuit,
consult with a licensed electrician.
Risk of Electrical Shock
• Turn off the power at your circuit breaker or fuse box before
continuing, consult with a licensed electrician if needed.
• Switch on/off the lights to make sure the electricity to the installation
area is shut off.
• Verify that the power supply is a 100~240 VAC 50/60 Hz power source.
• Keep the breaker off at any time during the installation process.
NOTE: Do not use a dimmer switch or timer for this product.
INSTALLING YOUR
FLOODLIGHT CAMERA
Separate the Mounting Bracket
Separate the mounting bracket from the camera and set it aside for later
installation.
Select a Location
You can mount the floodlight camera vertically on a wall or hang it from a
ceiling. With the power off at the breaker, remove the existing floodlight
if you have one.
WARNING: Risk of
electrical shock
Disconnect power at the
fuse or circuit breaker
before installing.
Verify that the supply
voltage is correct.
Connect fixture to a 100
VAC~240 VAC 50/60 Hz
power source.
Always follow code standards when installing wired
If you are outside of North America, installation and
wiring must be performed by a licensed electrician.
Wall Mounting Overhang Mounting
To Next Page
Loading...
Need help?
General