Choose a Location
• Do not install on rainy or hot days to avoid falling due to extreme temperatures or a
slippery ladder.
• Do not cut the light strips.
Determine the location of the first light strip section, making sure that the power adapter is
close enough to plug in and the control unit is accessible enough to operate.
Install the Light Strip
• You will need a ladder and make sure it is stable enough or use it with the help of
another person.
• Use the extension cable if needed.
1. Clean the surface with a cloth or tissue and wait until the surface is completely dry before
installing.
• Dust residue may aect the adhesion of 3M adhesive.
2. For the best wall-washing eect, the light strip should be installed 2-4 inches (5-10 cm) away
from the wall surface. Use the provided positioning card for measurement.
3. Peel the VHB adhesive from the back of each light, then firmly press the light against the
surface for at least 5 seconds.
• Do not overstretch the wires between lights and allow for flexibility in installation.
To Next Page
Loading...
