Eumig MINI 3 SERVOFOCUS - MOTOR; Adjustment; CIRCUIT BOARD

) lm Ni |
i
'F
m
¥y
a
‘|
NANA UAHA
MINI 3 servofocus PMA
——_———————
Motor
Remove intermediate gear G and washer H. Unsolder motor connections.
Remove screws J.
ADJUSTMENT: Adjustment with screws at the motor governor
21V-3V 1a Each
Power consumption at 3 volts and blocked take-up friction and without
film-end switch: > 310 mA
Circuit board
ADJUSTMENT:
Feeler
L
pressed,
17
DIN
-
contact
spring
must
be
open.
Feeler in rest position 23 DIN - contact spring closed.
Resetting adjustment by contact spring M.
Check
single
shot
lever,
viewfinder
calibration,
lens
focusing
and
lightmeter
calibration.
siswize A
vi
fieon
! G
saece3
960'377/3 a
ovo
FE
515480577