Need help?Do you have a question about the EURA E2000-0110 T3 and is the answer not in the manual?
Safe handling, transport, and storage guidelines to prevent inverter damage.
Procedures for proper inverter installation, including cabinet and grounding requirements.
Instructions for safe and correct electrical connections and wiring.
Fundamental guidelines for ensuring reliable and safe inverter operation.
Comprehensive technical specifications and data for the E2000+ series.
Table detailing power ranges and corresponding framesizes for E2000+ inverters.
Guidelines for mounting the inverter within a cabinet, including distance requirements.
Wiring diagrams and terminal configurations for 230V single-phase inverters.
Wiring diagrams and terminal configurations for 400V three-phase inverters.
Details on control board terminals and their functions for different inverter sizes.
Configuration and functions of digital input channels for E1-E6 and C3-C6 inverters.
Configuration and functions of analogue input channels Al1 and Al2 for E1-E6 inverters.
Steps for navigating, selecting, modifying, and saving parameter values.
Settings for control algorithms and essential motor parameters.
Configuration of start frequency, ramp times, and frequency limits.
Parameters for setting internal speed references, acceleration/deceleration ramps, and reversion.
Configuration of V/Hz characteristics and user-defined voltage-frequency curves.
Configuration of start/stop commands and rotation direction.
Selection of primary and secondary sources for speed reference signals.
Setting up analogue inputs for speed reference signals.
List of error codes, descriptions, reasons, and remedies.
Stored fault codes and parameters for diagnostics.
Instructions for programming motor data and using autotuning.
Steps for performing dynamic and static autotuning procedures.
Tuning parameters for the PID controller.
To Next Page
General