Eureka 3670 - Page 14

ENGLISH
To Replace HEPA Filter (on some models)
Step 1:
Grasp the bottom clips
l
O
on the filter
l
I
(Fig. 13).
Step 2: Pull out and down to release (Fig. 13).
Replace with filter, part number 60666.
To Re-install HEPA Filter (on some models)
Check the HEPA filter
l
I
with each disposable dust bag
change. Replace twice a year or after every six bag
changes as needed.
Step 1: Insert upper filter corner tabs
l
P
firmly under
rear housing tabs
l
Q
(Fig. 14).
Step 2: Pivot filter
l
I
down until bottom clips
l
O
on filter
click securely into place on the cleaner (Fig. 14).
To Clean the Motor Filter
CAUTION: Turn off vacuum and unplug the
electrical cord before cleaning the motor
filter. Never operate the vacuum cleaner
without the motor filter in place.
Step 1: Remove the dust bag. See pages 12-13 for details.
Step 2: Grasp filter
l
R
and pull out to remove (Fig. 15).
Step 3: Rinse under warm water.
Step 4: When all parts are completely dry, replace filter
and disposable dust bag (see pages 12-13 for
more details).
FIG. 13
FIG. 14
FIG. 15
14
l
R
l
P
l
I
l
O
l
Q
l
O
l
O
l
I