Eureka Central Vacuum System
Installation Guide
TOOLS NEEDED FOR INSTALLATION
Drywall saw (optional)
Electrical tape
Electric drill—1/2" (1.3cm) with right-angle head
if possible
Flashlight
Forstner wood-boring bit—2-1/4" (5.7cm)
Hammer
Hole saw or cutter—2-1/4" (5.7cm)
Masonry bit—2-1/4" (5.7cm) (optional)
Metal coat hangers
HELPFUL HINTS FOR INSTALLATION
Use a tubing cutter for cleaner cuts.
Use 2-1/4" wood boring bit similar to a Forstner bit.
Rent a right-angle drill if you do not have one.
LOOK FOR OTHER HELPFUL HINTS INSIDE
THIS MANUAL.
Pencil
Pipe/tubing cutter or hacksaw and miter box
Safety goggles
Screwdrivers (Phillips and Áat blade)
Steel tape measure
Stud Ànder
Utility/razor knife
Wire stripper/cutter
Wood chisel
30' (9.15m) piece of cord or string
To Next Page
Need help?
General
