13
How to use your robot
Operation
Short Press
Start/pause/
resume
Shut down /
Enter the
network
pairing state
Return to
the base
Start spot
cleaning
Press and
hold for 3s
Button
▪ Start / Pause / Resume
Briefly Press " " to start/pause/resume cleaning or use your
App to control.
▪ SPOT Cleaning
When the robot vacuum is in standby/pause mode, press " "
to start spot cleaning. The robot will begin to clean an area of
one square meter centered on itself. After spot cleaning, the
robot will automatically return to the charging base to recharge.
Note that starting the spot cleaning mode will automatically
stop the current cleaning cycle.
1.0m 1.0m
1.0m 1.0m
▪ Recharge
1. When the robot vacuum is in standby mode, press " " and
the robot vacuum will start recharging.
2. When the robot vacuum is in cleaning process, pressing " "
can stop cleaning, and then press " " can start recharging.
Under special circumstances (such as power depletion, robot
vacuum jamming, etc.), the robot vacuum may not
be able to recharge automatically. Please manually place the
robot vacuum back to the charging base.
NOTES
1. The robot vacuum will enter sleep mode when it is in
standby mode for more than 10 minutes. In sleep mode,
press any key to wake up the robot vacuum.
2. Do not immerse the robot in water. Doing so may damage
the equipment, causing short-circuit or current leakage.
To Next Page
Loading...
