Need help?Do you have a question about the Eurekazone EZSMART and is the answer not in the manual?
General| Brand | Eurekazone |
|---|---|
| Model | EZSMART |
| Category | Tool Storage |
| Language | English |
Connects one corner, one end rail, and one side rail using provided connectors and hardware.
Attach support connectors to side support brackets using hex screws, leaving them loose.
Slide end support brackets/connectors into end rails and side support brackets/connectors into side rails.
Repeat the assembly steps for the diagonally opposite corner.
Join the two assembled corner-rail units, ensuring vertical connectors face outwards.
Install SME Legs onto the vertical connectors of each corner, resting against side rails.
Install T-Track Leg Braces between legs, 8 inches from the bottom, with lip towards the top.
Install feet with connectors into the bottom of the SME Legs and adjust for floor irregularities.
Attach the Clamping Bench Top to the end and side supports using pan head screws.
Attach the Frame Brace to the bottom channel of each side rail using provided hardware.
To Next Page