A
INSERTING THE BOBBIN
9
1. Insert the bobbin in the bobbin case with
the thread running in a counterclockwise
direction (arrow).
2. Pull the thread through the slit (A).
3. Pull the thread toward the left and along
the inside of the spring until it slips into the
notch (B) being sure that the thread does
not slip out of the slit (A).
4. Pull out about 15 cm (6 inches) of thread
and attach the bobbin cover plate. (C)
When inserting or removing the bobbin,
the needle must be fully raised.
Attention: Turn power switch to off ("O")
before inserting or removing the bobbin.
A
B
B
1
3
2
4
C
To Next Page
Loading...
Need help?
General
