•
MENU SETTINGS
Menu items
Display Function
Setting the DMX starting address
Fog output volume for wireless remote operation (0 to 5)
Setting the wireless remote control
Setting the fluid sensor
Operating buttons
Button Function
MENU Selecting menu items
ENTER Editing menu items and confirming settings
▲/▼ Setting values
CONTROL VIA WIRELESS REMOTE CONTROL
For wireless remote control operation, disconnect the DMX cable from the unit and configure the function in the
menu.
Adjusting the fog output volume
Adjust the fog output volume by pressing the MENU button until the graphic depicted on
the left here is being displayed. Then press ENTER to make your settings. Change the
▲
output volume with the buttons
▼
and from 0 to 5. Once again, press ENTER to confirm
your settings.
Fog output on/off
1
Press the left button on the remote control to emit fog. The control LED lights.
2
To stop the fog output, press the right button.
Switching the remote control on/off
To set the remote control, press the button MENU until the display indicates “rEno“. Then
press ENTER to make your settings. Use the buttons ▲ and ▼ to deactivate the remote
control (indication “off”) and to reactivate it (indication “on”). Once again, press ENTER
to confirm your settings.
Assigning the remote control
If the remote control working properly when taking the unit into operation, it must be
assigned to the unit. The remote control can be assigned during a short period of time
after switching on the machine as long as the display shows the indication to the left. To
assign the remote control, press and hold one of the buttons until the display flashes
repeatedly, to indicate a match. This can take up to 12 seconds. Thus, the remote control
has been assigned to the machine and may be used for wireless control.
To Next Page
Loading...
Need help?
General
