44
Remote control
A. On/off (standby) button
B. Function selection button
- Low power heating
- High power heating
C. Oscillator/swivel button
D. Timer key
E. Temperature setting button
F. Temperature higher
G. Temperature lower
The remote control works on a button cell battery, Type CR2025
(3V).
Location and connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Place the 2 supporting brackets supplied with the screws on either side of the handle.
Check to make sure the on/off switch is set to 'OFF' (O).
Unwind the electrical cable completely and insert the plug into a suitable 220-240V
socket. To prevent overloading, check that no other equipment is connected to the
same group.
Note: The heater can be used both vertically and horizontally . The heating
capacity is optimal in the vertical position, however.
Operation
Operating manually
1. Press the on/off button on '-' = on. The display shows the ambient
temperature and all function images briefly, see figures 1 and 2. The heater is now in
standby.
To Next Page
Loading...
Need help?
General