Euromatic CH2MTF - Page 10

10
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Operating Instructions (Cont.)
Fan strength
• When turning the heat select dial to the [ I ] position, the heater blows warm
air, working at a lower fan strength.
• When turning the heat select dial to the [ II ] position, the heater blows warm
air, working at a higher fan strength.
• When turning the heat select dial to the [ I ] position, the heater blows
warm air, working at a lower fan strength while oscillating.
• When turning the heat select dial to the [ II ] position, the heater blows
warm air, working at a higher fan strength while oscillating.
Temperature adjustment
• Turn the thermostat dial to its maximum position (clockwise).
• When the room reaches the desired temperature, turn the thermostat dial
anti-clockwise slowly, until the appliance switches off. The thermostat
switch will then maintain the desired room temperature automatically.
• If you wish to change the temperature, you can turn the thermostat knob
either anti-clockwise or clockwise to make the temperature lower or
higher.