After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
3
Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
Read this manual thoroughly before rst use, even if you are familiar with this type of
product. The safety precautions enclosed herein reduce the risk of re, electric shock and
injury when correctly adhered to. Keep the manual in a safe place for future reference,
along with the warranty card and purchase receipt. If applicable, pass these instructions
on to the next owner of the appliance.
Always follow basic safety precautions and accident prevention measures when using
an electrical appliance, including the following:
Electrical Safety and Cord Handling
• Electrical connection: The unit comes with a plug ready for connection to your mains
power outlet.
• Voltage: Before turning on the air conditioner, ensure the electrical voltage and circuit
frequency correspond to those indicated on the appliance.
• Socket: Ensure your electrical outlet is properly installed and earthed and complies
with your local electrical safety requirements.
• Moisture: To reduce the risk of electrocution, never operate the appliance with wet
hands; never submerge it in water or spill liquids into it. Do not use it in a bathroom or
laundry, or where it can be splashed with water.
• Power supply cord: Do not kink or damage the cord. Do not pull the cord or place it
near a heat source. Always unwind the cord completely to avoid overheating. Run the
cord in such a way so that no one will trip over it.
• Extension cord/adaptor: Do not use this appliance with an extension cord or power
adaptor.
• Damage: If the supply cord (or any other part of the appliance) is damaged, do not use
the appliance. A damaged power supply cord must be replaced by the manufacturer or
its service agent or a similarly qualied person in order to avoid a hazard. Contact our
after sales support centre.
• WARNING: Do not use when damaged! In case of damage, switch o the appliance,
unplug it and contact our after sales support centre. Do not pick up or operate a damaged
appliance, or after it malfunctions or has been dropped or damaged in any manner.
• Switchingon/o: Do not use the mains plug to start and stop the unit; always use the
POWER button to start and stop the unit.
• Disconnect: Turn o the unit rst and then unplug it when it is not in use and before
maintenance or cleaning, but do not unplug it when it is in operation, as this could create
a spark and cause a re. Grip by the plug, do not pull by the cord when disconnecting.
• RCD: The installation of a residual current device (safety switch) is recommended to
provide additional safety protection when using electrical appliances. It is advisable
that a safety switch with a rated residual operating current not exceeding 30 mA
be installed in the electrical circuit supplying the appliance. See your electrician for
professional advice.
To Next Page
Loading...
