Euromatic RCH22W - Timer Function and Settings

12
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Instructions (Cont.)
OFF-timer
When the heater is operating, press the SETTING [ S ] button to enter timer mode.
When the timer indicator is flashing on the display, use the [ + ] and [ - ] buttons
to set the time period (between 1 to 15 hours), after which you want the heater
to stop working and return to standby mode. The heater will start counting down
after 5 seconds, or press the SETTING [ S ] button again to start the countdown
immediately. On the display, the timer indicator will illuminate.
To reset the timing, press the SETTING [ S ] button again.
At the end of the set timer period, the appliance will stop heating and return to
standby mode.
Auto mode
To enter auto mode, press the MODE [ M ] button until the auto indicator
illuminates on the display. The heater starts working with full power (4 tubes = 2200W)
and all heating indicators are illuminated on the display.
In auto mode you can set the desired temperature within the 15°C–32°C range
using the [ + ] and [ - ] buttons. The set temperature will flash for 5 seconds on the
display and then illuminate steadily. Alternatively, press the SETTING [ S ]button to
confirm the temperature immediately. The heater will start working with full power
(all 4 tubes are lit up), and the ambient (room) temperature will be shown on the
display.
When the room has warmed up to the set temperature, the heater will turn off
2 tubes and operate with 2 tubes only. It will again start operating with full power
(4 tubes) when the temperature has dropped below the set temperature.
NOTE: The heater's open window sensor is active in auto mode.
Sleep mode
To enter sleep mode, press the MODE [ M ] button until the sleep indicator
illuminates on the display. The heater starts working with full power (4 tubes = 2200W)
and all heating indicators are illuminated on the display.
To set an off-timer, follow the instructions below.
NOTE: The heater's temperature and open window sensors are active in normal mode.