EUROSEC CP 8 User Manual

CC
CC
PP
PP
77
77
//
//
CC
CC
PP
PP
88
88
II
II
NN
NN
SS
SS
TT
TT
AA
AA
LL
LL
LL
LL
AA
AA
TT
TT
II
II
OO
OO
NN
NN
II
II
NN
NN
SS
SS
TT
TT
RR
RR
UU
UU
CC
CC
TT
TT
II
II
OO
OO
NN
NN
SS
SS
TM
TM
ENGINEER.qxd 16/08/01 13:42 Page 1

EUROSEC CP 8 Specifications

General

Brand	EUROSEC
Model	CP 8
Category	Control Panel
Language	English

Summary

Introduction

Mains Safety

Essential safety measures for connecting the control panel to the mains supply.

Installation

Control Panel & RKP Location

Wiring

General Detector Wiring

Suggested colour scheme and methods for wiring various types of detectors.

Wiring Global Tampers

General Bell Box Wiring

Control Panel Connections

Diagram and explanation of the control panel's terminal connections.

Programming

Engineer Programming Mode

Detailed guide on entering and using the engineer programming mode.

Programmable Engineer Options

Explanation of programmable options for zone types, timings, and modes.

Reset Modes

Service Timer

Engineer/User Mode

How the engineer can operate the system in user mode.

Engineer Reset (After an Alarm)

Procedure to reset the system by an engineer after an alarm.

Anti-Code Reset (After Alarm or Service Timer Lockout)

Steps to perform an Anti-Code reset for alarms or service timer lockouts.

Resetting to Factory Defaults

Instructions on how to reset the unit to its original factory settings.

Troubleshooting

Control Panel Power Issues

Actions to take when the control panel fails to power up from the mains supply.

Zone Faults and Setting Failures

Diagnosing and resolving zone faults that prevent system setting.

Tamper Faults

Troubleshooting steps for control panel tamper fault indications.

Detector Not Registering

Sounder Issues

False Detector Alarms

Code Recovery

Procedures for recovering forgotten engineer or user codes.