Need help?Do you have a question about the EUROSEC CP7 and is the answer not in the manual?
Set system by pressing Quick then Full.
Set system by entering User Code then Full.
System provides exit tone; user must exit via authorised route.
Pressing Quick key during exit shortens exit time to 3 seconds.
Enter a valid User Code to abort the exit sequence.
Set system using Part 1 by pressing Quick then Part.
Set system using Part 1 by entering User Code then Part.
User must retire to an unprotected area after setting.
Notes on exit time adjustment and aborting exit apply.
Set system using Part 2 or 3 by pressing Quick then 2 or 3.
Set system using Part 2 or 3 by entering User Code then 2 or 3.
User must retire to an unprotected area after setting.
Notes on exit time adjustment and aborting exit apply.
Enter the premises through a designated and authorised entry point.
The system will emit an entry tone upon authorised entry.
Proceed to keypad and enter a valid User Code to unset.
Reset system by pressing Reset if Any Code Reset is programmed.
Reset system by entering User Code then Reset.
Insurance terms may prohibit User reset; contact installer if needed.
Enter User Code followed by No to access zone removal programming.
Pressing 4 after entering code displays zones for removal.
Press keys corresponding to zones to remove from the next Set.
Press 0 twice to confirm zone removal selection.
Press Set Key (Full, Part, 2, 3) to set with selected zones omitted.
Enter User Code followed by No to initiate system test.
Pressing 5 displays zones for testing.
Violate each zone; its LED extinguishing verifies integrity.
Press 9 to test bells and strobe; press 9 again to stop.
Press 0 three times to escape test mode and return to Unset.
Enter User Code followed by No to access chime control.
Pressing 7 displays chime status (LEDs 1-7).
Press No to change chime status if LEDs 1-7 are On or Off.
Press 0 three times to escape chime control and return to Unset.
Details Master (1-3), User (4-7), and Set Only (8-9) levels.
User Number 1 is factory default 5678 and can only be changed.
Enter User Code followed by No to begin programming.
Pressing 9 after entering code displays programming options.
Enter a single digit for the User Number to program.
Enter the four-digit code required for the user.
Display indicates if code was accepted; try different code if not.
Provided code accepted, press 0 twice to escape to Unset.
General| Brand | EUROSEC |
|---|---|
| Model | CP7 |
| Category | Control Panel |
| Language | English |
To Next Page
