EVAC reserves the right to make alterations to this specication without prior notice.
© Copyright Evac Oy. All rights reserved.
2
VACUUM TOILET
INSTALLATION
Date:
Doc.
09 Dec 2010
002503-2
6546819 PRESTIGE SOFT CLOSING, SEAT AND COVER
3. Install the seat and the cover with the hinges on
the installation screws on the bowl.
Installation
screws
4. Tighten the retaining screws by the hex wrench.
(The installation kit includes two hex wrenches.)
Hex wrench
Maintenance
The seat is easy to clean, with just a few simple directions for you to observe.
• Use mild soap solution or biological cleaners.
• Rince the seat and cover and the hinges with water and dry with a soft cloth.
• Do not use abrasive scouring powders for the seat and cove and the hinges.
• Be careful with chemicals and cosmetics. Some of them may damage the seat at last.
• When you use abrasive, corrosive or chlorine based cleaners for the bowl, avoid contact with
the seat and cover and the hinges. Therefore, when you clean the bowl and ush cleaner
away, make sure that the seat and the cover are in an upright position.
! NOTE: Do not use too much force.
Do not use force when closing, this may cause
irreparable damage to the device.
To Next Page
Loading...