EvaKool DOWN UNDER II Series User Manual

• Unscrew the screw from the upper half of the housing.
• Carefully raise the upper half of the housing from the lower half.
• Take out the contact pin.
• Replace the defective fuse with a new one that has the same rating (15A, 250V).
• Re-assemble the plug in the reverse order.
Replacing the light
• If you require a new LED light please contact Evakool on 1300 385 665.
• The LED light is located internally on the outer le and right hand sides.
• Disconnect the power supply.
• Carefully pry out the plastic light cover with a pointed and flat tool.
• Unscrew the LED mounting screws.
• Pull out the LED.
• Replace them with a new LED.
• Fit the screws in with a screwdriver.
• Press the transparent part of the lamp back into the housing.
• Connect the power supply to the fridge.
If none of the above solves your issue please contact Evakool on 1300 385 665 or
warranty@evakool.com.au for details of your closest Evakool service centre.
DOWN UNDER SERIES II
14

EvaKool DOWN UNDER II Series Specifications

General

Brand	EvaKool
Model	DOWN UNDER II Series
Category	Cooling boxes
Language	English