Evans Evaglide ROMAN - Remote and Motor Configuration; Copying Remote Settings; Changing Motor Direction; Fine-Tuning Limits

For more guides and videos visit www.evans-textiles.com/resources
4
To copy to another remote
• Remote A = remote already paired – remote B = Remote we wish to copy to.
• While on remote blind is paired to press P2 on remote. Blind will shunt. Press P2
again and blind will shunt.
• Press P2 on Remote B. Blind will shunt. Channel A is now copied onto remote B.
To copy to another channel
• Channel A = Channel already paired – Channel B = Channel we wish to copy to.
• While on channel blind is paired to press P2 on remote. Blind will shunt. Press P2
again and blind will shunt.
• Change to required channel.
• Press P2 on Channel B. Blind will shunt. Channel A is now copied onto Channel B.
To remove all settings (This will remove pairing to remote)
Press and hold button in Motor until 4
th
Shunt.
To change motor direction
Press and hold button in motor until 3
rd
Shunt.
• To Fine Tune Limits after initial setting
• Upper Limit – Press and hold STOP and UP together until blind shunts.
• Press UP or DOWN until at desired limit.
• Press UP AND STOP together until blind shunts. Upper limit now reset.
• Lower Limit – Press and hold STOP and DOWN together until blind shunts.
• Press UP or DOWN until at desired limit.
• Press DOWN AND STOP together until blind shunts. Lower limit now reset.
Adjust motor speed (please note factory default is at fastest speed)
• Press P2 button on remote. Blind will shunt.
• Press UP to increase speed OR press DOWN to decrease speed. Blind will shunt.
• Press UP to increase speed OR press DOWN to decrease speed. Blind will shunt
again.
• If no shunt, then Motor is already running at that speed.