Eve Audio SC203 - User Manual

PACKAGE CONTENT
► Master + Slave Monitors
► Stereo Link Cable
► External PSU
► 2 x FlexiPad
► Product manual
1
2
AUDIO CONNECTIONS
► Connect the signal source with either both analog RCA L/R ins, the digital optical input or the USB port.
► Link both SC203 Master and Slave monitors using the provided 4-pin connection cable.
Right monitor (Master) Left monitor (Slave)
ANALOG AUDIO SOURCE:
Soundcard, mixer, synthesizer, MP3/CD/DVD player, laptop, etc.
DIGITAL USB AUDIO SOURCE:
Soundcard, MP3/CD player, computer, etc.
DIGITAL OPTICAL AUDIO SOURCE:
Soundcard, mixer, synthesizer, SACD/CD/DVD player, etc.
OR
OR
3
POWERING ON
► Connect the Master monitor (right
speaker) to AC mains power using the
provided external PSU.
► On the Master monitor rear panel,
make sure that the Satellite lter DIP
switch is in OFF position.
4
SELECTING INPUT
► Briey push the front-panel encoder to switch the system on.
► Push the encoder to enter menu: "Bal" LED should blink.
► Turn the encoder clockwise until "Input" LED starts blinking.
► A constantly lighting LED shows the selected input. Turn the
encoder to select the input connected to the signal source:
- Top LED (#12) is lighting: Analog RCA L/R inputs
- Next LED clockwise (#13) is lighting: Digital optical input
- Next LED clockwise (#14) is lighting: USB port
► Push & hold the encoder for 3 sec. or don‘t touch it for 10 sec.
to quit the menu.
► Turn the encoder to adjust the system volume and refer to the
product manual to know everything on your SC203 system!
Analog in
Digital in
USB port
QUICK START GUIDE
EVE AUDIO SC203 MASTER/SLAVE SYSTEM
English

Summary

Audio Connections

Signal Source Connectivity

Connect analog RCA, digital optical, or USB to the signal source.

Monitor Linking

Link Master and Slave monitors using the provided 4-pin cable.

Powering On Procedure

AC Power Connection

Connect the Master monitor to AC mains power using the external PSU.

Satellite Filter DIP Switch Setting

Ensure the Satellite filter DIP switch on the Master monitor is OFF.

Input Selection and Volume Adjustment

System Power On and Input Selection

Push encoder to turn on, then select input (Analog, Optical, USB) via blinking LEDs.

Volume Control

Turn encoder to adjust system volume after input selection.

Front Knob Operations

Volume Setting

Turn the encoder to adjust system volume. LEDs indicate volume level.

Standby Mode

Push and hold encoder for 3 sec. to enter/exit standby mode.

Function Menu Navigation

Push encoder to enter menu, turn to select functions (mode, shelf, balance, input).

Listening Position Setup

Select listening position (Flat, Desk, Console) based on LED indicators.

Eve Audio SC203 Specifications

General

Type	Active studio monitor
Tweeter Size	1 inch
Tweeter Type	AMT (Air Motion Transformer)
Amplifier Power (per speaker)	50 W
Amplifier Power (Tweeter)	20 W
Frequency Response	62 Hz - 21 kHz
Inputs	RCA, 3.5mm jack
Outputs	Subwoofer Output