Legal Information
•
Informations légales
•
Rechtliche Hinweise
This device complies with part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operati-
on is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, you are encouraged to try to correct the interference by one or more of the following measures: reorient
or relocate the receiving antenna; increase the separation between the equipment and receiver; consult the
dealer or an experienced radio/TV technician for help. • This Class B digital apparatus complies with Canadian
ICES-003.
This equipment complies with FCC RF and IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters bet-
ween the radiator and your body. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation
distance of at least 0.5 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
Changes or modifications not expressly approved by Elgato Systems could void your authority to operate this
device. Purpose
of control: operating control; construction of control: plug-in operating control; type 1 action,
operating time: continuous.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement. Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
Cet équipement est conforme aux CNR-102 d’Industrie Canada. Cet équipement doit être installé et utilisé avec
une distance minimale de 0.5 centimètres entre le radiateur et votre corps. Cet émetteur ne doit pas être co-loca-
lisée ou opérant en conjonction avec autre antenne ou émetteur. Les antennes utilisées pour cet émetteur doivent
être installés et fournir une distance de séparation d’au moins 0.5 centimètre de toute personne et doit pas être
co-située ni fonctionner en conjonction avec une autre antenne ou émetteur.
For questions about Elgato product compliance with FCC regulations, please contact: Compliance Officer, Elgato
Systems, 900 Kearny St. #750, San Francisco, CA 94133. Product: 10EAS8301 / 10EAS4101 • Model: 20EAS9901
& 30EAS9901 • Part: 51EAS9901 • FCC ID: SNE-LST-001 • IC: 11192A
LST001
Hereby, Elgato Systems declares that this device is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EC. The declaration of conformity is available at www.elgato.com/doc
Frequency range: 2412 - 2472 MHz (2462 MHz for FCC, ISED), Max RF e.i.r.p power < 20 dBm, Temperature
range: 0 °C - 45 °C
To Next Page
Loading...