76
Before First Use
Before Every Use
• Wash your hands with soap and water before handling your pump.
• Ensure parts are clean and dry. Refer to cleaning instructions on page 14.
• Use care when handling the valve/membrane assembly to avoid damage.
• Visually inspect the individual components for cracks, chips, tears,
discoloration or deterioration. In the event that damage to the device
is observed, please discontinue use until the damaged parts have been replaced.
Assembling the Flange
1
2
Attach the membrane A to the valve B.
Ensure membrane can move by gently
lifting the membrane away from the valve.
The membrane should return to lie flat
against the valve.
Push valve assembly C onto the bottom of
the flange D. Screw bottle E into
bottom of flange.
3
Install diaphragm F and diaphragm
cap G on to flange assembly H.
Note: Diaphragm cap can can be turned to
orient tubing as desired.
4
Attach tubing I to diaphragm cap G.
Note: If you intend to pump from both
breasts at the same time, repeat steps 1
through 4 for the second flange.
B
A
D
C
E
F
G
Note: If the membrane is not lying flat against the valve, the pump will lose suction
and will not work properly. Also, make sure the membrane is not torn, as this too
will cause decreased suction and the pump not to work properly.
G
H
I
WARNING
NEVER immerse pump unit or AC adapter in water or attempt to sanitize in a microwave oven. Damage
to parts and oven may occur. Do not boil or wash tubing or tubing adapter. Wipe the pump unit with a
clean, damp cloth as needed.
Clean Your Pump Parts
AC Adapter
Pump Unit
Tubing Adapter Tubing
To Sanitize Parts on the Stove:
Place disassembled pump parts in a pan of
boiling water for 5 minutes. Stir frequently. DO
NOT allow parts to rest on bottom of pan as
they may melt or become damaged.
To Sanitize Parts in the Microwave:
Please follow sanitation device instructions.
IMPORTANT
DO NOT BOIL OR SANITIZE
IN MICROWAVE. Boiling or
sanitizing in the microwave will
damage these parts and the
PUMP WILL NO LONGER WORK.
PARTS THAT MAY BE SANITIZED: PARTS THAT ARE HAND WASH ONLY:
DO NOT WASH:
Diaphragm Cap
Bottle
Flange
Inserts
Sealing
Disc
Bottle
Cap Ring
Valve Membrane
Flange
Diaphragm
To Next Page
Loading...
Need help?
General
