Evenflo Amp - Using the Booster Seat; Product Installation and Use

1. Place the booster seat on the vehicle seat.
2. Set the child in the booster seat.
Make sure the child’s back is flat against the vehicle
seat, and the child’s bottom is flat against the booster
seat.
3. Secure the child and booster seat to the
vehicle seat.
Stretch the lap/shoulder belt under the armrests and
across the child and fasten the buckle.
4. Use the shoulder belt clip, if necessary.
If the shoulder belt does not properly lay midway
between the child’s shoulder and neck, attach and
adjust the belt clip (see Using the Shoulder Belt Clip,
pages 12/13).
5. Check your work.
Make sure the lap belt is stretched low and snug
across the child’s hips, beneath the armrests, and
fastened into the buckle. The shoulder belt must
cross the child midway between his/her shoulder and
neck. Note: If the vehicle’s shoulder belt naturally
crosses the child’s shoulder, you do not need to use
the shoulder belt clip.
Using the Amp™
No-back Booster Seat
IMPORTANT
Always secure the booster seat with the vehicle seat belts when
not occupied. An unsecured booster seat can fly into and injure
other occupants during a sudden stop or crash.
Lap Belt: Stretched low
and snug across the
child’s hips, beneath the
armrests, and fastened
into the buckle.
Shoulder Belt: Must cross
midway between child’s
shoulder and neck.
Use belt clip, if necessary.
Child Requirements
Weight: 18 – 49.8 kg (40 – 110 lbs)
Height: 102 – 145 cm (40 – 57 inches)
Age: At least four years old
Ears below the top of the
vehicle seat headrest
The shoulder belt MUST NOT cross the child’s neck or
fall off the child’s shoulder. If you can not adjust the
shoulder belt to properly lay midway between
the child’s shoulder and neck, try another seating
location or do not use the booster seat.
WARNING
10 11
Route lap/shoulder belt under armrests ONLY.
WARNING