Evenflo Amp - Shoulder Belt Clip Usage

Using the Amp™ Shoulder Belt Clip
12 13
Using the Amp™ Shoulder Belt Clip
Styles may vary. Styles may vary.
E
D
A
E
D
C
1. Remove the shoulder belt clip harness A from the
storage area B beneath the booster C.
Note: Be sure to remove rubber band around the
strap and dispose of properly.
2. Place booster C on the vehicle seat and attach the
shoulder belt clip A to the shoulder belt D.
3. Pull the adjustment strap E until belt clip A is even
with the child’s shoulder and the shoulder belt D
lays across the child’s chest midway between his/her
shoulder and neck.
4. To store the shoulder belt clip harness, fold it and
place it in the storage area B.
Child Requirements
Owner’s Manual
Keep for future use
To
reduce the risk
of serious
i
n
j
u
ry
or death
,
r
ead this
owner’s
manual p
rior
to installi
ng and using
thi
s
child
restrai
nt.
WARNING:
© Evenflo Company
2570XXX
X
XX to XX kg
(XX to XX lbs.)
XXX to XXX cm
(XX to XX in.)
Para instr
ucciones en Español,
llamar al: 1-800-233-5921
Child Requirements
Owner’s Manual
Keep for future use
To
r
educe the risk of serious injur
y
or deat
h,
read this ow
ner’s manual pri
or
to installing and using this child restraint
.
WARNING:
© Evenflo Company 257
0XXXX
XX to XX kg
(XX
to
XX lbs.)
XXX to XXX
cm
(XX to XX in.)
Para instrucciones en Español,
llamar al: 1-800-233-5921
A
C
B
Child Requirements
Owner’s Manual
Keep for future use
To reduce the risk of serious injury
or death, read this owner’s manual prior
to installing and using this child restraint.
WARNING:
© Evenflo Company 2570XXXX
XX to XX kg
(XX to XX lbs.)
XXX to XXX cm
(XX to XX in.)
Para instrucciones en Español,
llamar al: 1-800-233-5921
Child Requirements
Owner’s Manual
Keep for future use
To reduce the risk of serious injury
or death, read this owner’s manual prior
to installing and using this child restraint.
WARNING:
© Evenflo Company 2570XXXX
XX to XX kg
(XX to XX lbs.)
XXX to XXX cm
(XX to XX in.)
Para instrucciones en Español,
llamar al: 1-800-233-5921
B
C
A
1. Thread the looped end of the shoulder belt clip
strap A through the anchor point on the back of
the booster B.
2. Thread the shoulder belt clip C through the loop at
the end of the strap A and pull until tight.
3. Place booster B on the vehicle seat and attach the
shoulder belt clip C to the vehicle shoulder belt D.
4. Pull the adjustment strap E until belt clip C is even
with the child’s shoulder and the vehicle shoulder
belt D lays across the child’s chest midway between
his/her shoulder and neck.
C
A
B
D
If the shoulder belt does not properly lay midway between
the child’s shoulder and neck, attach and adjust the belt
clip for proper belt placement.
If the shoulder belt does not properly lay midway between
the child’s shoulder and neck, attach and adjust the belt
clip for proper belt placement.