13
Assembling Your Stroller
Push straight side of pin
through axle hole. Pin will
separate around the axle.
NOTE: Use needle nose pliers
to hold pin for easier assembly.
Attach hubcap to wheel
until it clicks into place once
the washer and hairpin are
attached.
To attach rear wheel assembly to
stroller, turn stroller over so back
tube is positioned as shown.
Push wheels onto rear leg tubes
until they click into place.
Pull on wheels to make sure both
of them are securely attached.
Brake levers point toward
rear of stroller
CLICK!
CLICK!
CLICK!
To Next Page
Loading...
