31
3
LAP BELT
LAP AND
SHOULDER BELT
Route ONLY the lap portion of the vehicle seat belt
through the vehicle belt slots C on the carrier.
In vehicles with a lap and shoulder belt D, DO NOT
route the shoulder belt through the belt slots. Instead,
let it lay across the vehicle seat back, as shown.
IMPORTANT: Some ELR vehicle belts can be switched so
that they lock when tightened. It may not be necessary
to use a locking clip in these situations.
To install a locking clip, refer to p. 41.
Refer to the vehicle owner’s manual to determine which
type of belt retractor is in the vehicle.
D
C
4
• NEVER use this child restraint in forward-facing position.
• DO NOT use this carrier if it moves more than 25mm
(1 in.) side-to-side or front to back at the vehicle belt
path. Serious injury or death may occur. Move the child
restraint to another seating location, or try to tighten
the vehicle belt again.
The vehicle belt E must be as tight as possible. Put your
full weight into the seat as you tighten the vehicle belt.
If you can move the child restraint more than 25 mm
(1 in.) side-to-side or front to back at the vehicle belt
path, the vehicle belt is not tight enough, and you need
to try again.
Push down on
the bottom of the
seat using your
full weight.
Tip!
Tip!Tip!
E
WARNING!
DEATH or SERIOUS
INJURY can occur.
To Next Page
Loading...
