41
Using the Locking Clip
E
F
F
When the lower anchor connector assembly is not in
use, you MUST securely store it in the area provided in
the bottom of the base E.
Route the harness strap through the belt path on top of
the base then attach the hooks to the slots F located on
each side of the storage area beneath the base.
A loose lower anchor assembly connector harness and
hook may injure your child.
3
To watch a video about installing a locking clip, go to
www.evenflo.com.
Locking Clip
installed properly.
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
Consult your vehicle owner’s manual before
installing a Locking Clip.
Install Locking Clip,
if necessary.
If your vehicle was
built prior to model
year 1996, and has
a lap/shoulder belt
that is equipped with
an emergency locking
retractor (ELR) AND sliding
latch plate, you MUST use
a Locking Clip. Check your
vehicle owner’s manual to
identify which vehicle belt
system is in your vehicle.
13 mm
(0.5 in.)
To Next Page