3
Grab the parents handle
B
near the top of the canopy and
pull upward until the stroller opens fully with an audible
click. Make sure the stroller locks in the open position.
Unlatch side frame lock
A
.
Continue holding the lock open
while unfolding the stroller.
ASSEMBLING YOUR STROLLER
1
2
A
NOTE: Hardware for front wheel assembly is located
on wheel.
Turn the stroller upside down so the front of the
stroller is facing upwards, as shown.
Loosen the nut on each side so that the forks
C
will fit under the silver tabs
D
. Slide the front wheel
onto the forks. Ensure the silver tabs fit into the
openings on the forks as shown. Use the wrench
tool
E
to tighten both nuts.
DO NOT inflate tires above the maximum
recommended inflation pressure listed on the side
of the tire. Over inflation may cause wheel and/or
tire to blowout and could result in serious injury.
Use manual bicycle pump to inflate tires.
B
C
E
D
B
A
To protect flooring, place a protective covering
(cardboard, towel, small rug or blanket) beneath
the stroller during assembly.
WARNING
Care must be taken when folding or unfolding
stroller to prevent finger injury in hinge areas.
WARNING
FALL HAZARD
Wheel can detach and cause tip over. Pull on the
wheel to assure it is securely attached. Periodically
check wheel to assure it is securely attached.
To Next Page
Loading...
