Evenflo JOURNEY - Stroller Assembly and Usage Setup; Installing Rear and Front Wheels; Canopy and Console Installation

B
P
Q
R
Turn the stroller upside down.
Install H-frame P to stroller frame legs Q until they lock into
place with audible clicks.
Hold the rear wheel/axle assembly so the brake levers R face
toward the handle and console.
Slide the brake housings onto the H-frame until they lock into
place with audible clicks.
Pull upward on the rear wheel/axle assembly to make sure it
is locked securely.
ASSEMBLING YOUR STROLLER
8
2
ASSEMBLING YOUR STROLLER
7
Slide the front wheel assembly S over the front frame leg T
until the locking tab U locks into place with an audible click.
Pull on front wheel assembly to make sure it is locked
securetly. Repeat for other side.
Note: To remove each swivel wheel, press locking tab U and
slide the wheel off the leg.
T
S
Insert the canopy support tubes V into the canopy hinges on
the stroller W until they lock into place with audible clicks.
Pull upward on the canopy tubes to make sure they are
locked securely.
Y
C
X
B
Bring the parent’s console B up to the parent’s handle C.
Gently pull out the side of the console and guide the hole X
over the post Y. Repeat on the other side of the parent’s
console.
Step on the rear brake levers B to lock the rear wheels on
the stroller.
To release the brakes, lift up on the brake levers.
USING YOUR STROLLER
1
Pull canopy hoop A forward to extend canopy.
Push canopy toward handle to close.
A
W
V
5
4
W
V
Begin assembly of the rear wheels and axle assembly by discarding all packaging.
Slide one wheel H and a steel washer I onto the axle J. Insert a clevis pin K through the end of the axle J to secure the
wheel, as shown. Make sure the clevis pin is completely pushed through the hole in the axle, and make sure the brake
housings L are facing the same direction. Note: An extra clevis pin and steel washer are included for your convenience.
Install the hub cap M on the wheel by lining up the notch N with the tallest rib O in the wheel hub. Insert the hub cap
completely until it snaps into place. Repeat on the other side.
J
H
M
K
J
K
I
I
N
O
L
M
U
5
6