ATTACHING THE TRAY ASSEMBLY
WARNING
• Care must be taken when attaching tray assembly to prevent
finger injury in hinge areas.
Position tray assembly A over snack tray B.
Push tray assembly down onto snack tray until it locks into one of the
three tray positions with an audible click on both sides.
Pull on tray to make sure it is locked in place.
There are two ways to adjust the tray assembly.
A) Pull tabs C outward on both sides of tray assembly and slide tray
assembly into one of the three positions.
B) Squeeze handle D on front of tray assembly and slide tray assembly
into one of the three positions.
Pull on tray to make sure it is locked in place.
Adjustment A Adjustment B
To Next Page
Loading...
