60
Lap/Shoulder Belt (Rear-Facing and Forward-Facing)
Installing Lap/Shoulder Belt (Preferred Method)
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
vehicle belt a little more, and try
again. If Base still moves too much,
you may need to try a different
vehicle seat location, installation
method, or both.
10. Lock the seat belt. In most vehicles,
you can switch your shoulder belt
retractor into locking mode by
pulling shoulder belt all the way
out and letting it rewind into the
retractor. Pull on shoulder belt to
make sure it is locking.
NEVER install this Car Seat using
a non-locking vehicle lap/shoulder
belt.
To Next Page
Loading...
